Installation guide glue mastic method

Glue mastic installation instruction

Important information

Position

Check surface

Make sure the contact surface flatness does not vary more than 3 mm.

Measure

Measure 48 inches (120 cm) from floor to top of bracket, and mark position of each contact surface with pencil or piece of masking tape.*

*For ADA (Americans with Disabilities Act) designated rooms – we recommend installation at 41 inches (104 cm) for accessibility.

Surface preparations

Cleaning

Clean all contact surfaces with isopropanol alcohol (IPA) to remove any greasy residue, let dry thoroughly prior to installation.

Install product

Apply glue

Install cover plugs in the bracket screw holes.

Apply the glue to the backside of bracket.

Place

Aim the bracket to the wall in level and press to ensure glue has spread over the contact surface.

Wait

Leave bracket on the wall for at least 12 hours before use*.

* Refering to when using recommended Casco XtremFix+

Place bottle

Use Spaza key

Place the Spaza key in the key slot, move the hook aside.

Place

Place the bottle and swing back the hook around the cap.

Documents

Discover the key to seamless product installation with our comprehensive guide about surface preparation and method selection for successful product installation. Gain expertise in method selection, empowering you to make informed decisions and achieve successful, lasting results.

Need assistance?

Discover the key to seamless product installation with our comprehensive guide about surface preparation and method selection for successful product installation. Gain expertise in method selection, empowering you to make informed decisions and achieve successful, lasting results.