Installation guide screw method
Screw installation guide
Important information
- Because Spaza cannot anticipate all of the different possible surfaces and contaminants that may exist, it is imperative that the user conduct an evaluation to determine the suitability of surface preparations procedures, and any other processes that may have an influence on the screw installation. Ensure you follow required local building codes for bathroom installations.
- Before installing our products, we recommend conducting a test installation in a designated room to assess functionality and compatibility. This proactive step helps identify and address potential issues before scaling up. Evaluate performance and ensure your team is familiar with the installation process. This preliminary trial enhances overall success and instills confidence in the seamless integration of our products throughout your hotel.
- Before installing, please make sure you have read our surface preparations and method selection section.
Position
Measure
Measure 48 inches (120 cm) from floor to top of bracket, and mark drill holes with pencil.*
*For ADA (Americans with Disabilities Act) designated rooms – we recommend installation at 41 inches (104 cm) for accessibility.
Drill
Drill holes, drill depth minimum 40 mm.
Wall anchors
Insert wall anchors into hole by carefully tapping with hammer
Surface preparations
Cleaning
If bracket comes with pre-applied adhesive tape:
Clean all contact surfaces with isopropanol alcohol (IPA) to remove any greasy residue, let dry thoroughly prior to installation.
- Don't rub across the contact surface. Wipe in a vertical direction then fold the cleaning wipe to a new side and wipe a final stroke in a vertical direction.
Install product
Remove strip
If bracket comes with pre-applied adhesive tape:
Peel of backing of adhesive strip on bracket, do not touch any of the adhesive tape or wall surface. Aim the bracket to the wall in level.
Place
Aim the bracket to the wall matching the drill holes.
Screw
Install with included screws through the bracket in to the wall anchors.
Place bottle
Use Spaza key
Place the Spaza key in the key slot, move the hook aside.
Place
Place the bottle and swing back the hook around the cap.
Need assistance?
Discover the key to seamless product installation with our comprehensive guide about surface preparation and method selection for successful product installation. Gain expertise in method selection, empowering you to make informed decisions and achieve successful, lasting results.